INNO Internal Implant
System Flow
INNO Internal Implant
Internal Fixture
Surface Treatment : SLA-SH®
- Interchangeable with 1 staged internal fixture.
- Internal octa connection (Taper 8°/ Octa 3.1).
- No-Mount type.
No-Mount Cuff 1.8mm Fixture
- Packing Unit : 1 Fixture + 1 Cover Screw
No-Mount Cuff 2.4mm Fixture
- Packing Unit : 1 Fixture + 1 Cover Screw
INNO SUB. FULL SURGICAL KIT
[KCA010F]
- For the INNO Internal Implant System (Int.).
- All components are for Sub. / Int. / Ext. except for the Fixture Drivers used for Int. exclusively.
Drilling Sequence E.g. 12mm Fixture
Minimal drill frequency with the Point Drill, Initial Drill and Final Drills
(Ø3.5, Ø4.0 and Ø4.5 Fixtures).
Length Marking
Actual length of Drill : Fixture + 1mm
Ø5.0 fixture : a series of the Point Drill, Initial Drill, Ø4.0 Final Drill and Ø5.0 Final Drill.
Ø6.0 fixture : a series of the Point Drill, Initial Drill, Ø4.0 Final Drill, Ø5.0 Final Drill and Ø6.0 Final Drill.
※ The Countersink and Tap Drill are used in hard bone quality.
※ Sloped edentulous ridge adjacent of tooth
Crestal cutter of the Initial Drill and Final Drill.
Longer drills than fixture’s length.
※ Wide extraction socket
Absence of the cortical bone & spongy bone.
Narrower diameter than the fixture’s diameter.
※ Torque force control
The 0.5mm deeper placement increases the initial torque force of fixture.
The pumping action of drill removes the bone chip in the hole.
In dense bone, the debriment action decreases the high torque force.
※ In weak bone quality 4 of maxillary tuberosity
No pumping action.
0.5mm deeper placement of fixture.
Wider fixture than Final Drill.
